P/N:801004

Heated Safety Station with Eye/Face Wash. cover ABS .middle Inlet

Application: In areas where electricity is available, heat-traced safety stations provide excellent protection against freezing. Units are heated by self-limiting heat tracing cable wrapped around internal pipe. Thermostat regulates heating. Units are insulated and jacketed for protection against weather. Since units are intended for use in cold weather conditions, consideration should be given to supplying unit with tempered water in accordance with ANSI Z358.1-2004. See “Tempering Units” section for more information.

Shower Head:10〞diameter ABS. high visibility and corrosion resistance.

Shower Valve: 1〞IPS stay-open ball valve. Furnished with stainless steel actuating arm and 29〞stainless steel pull rod.

Spray Head Assembly: Two spray heads. Each head has a dust cover.

Eye/Face Wash Valve: 1/2〞IPS stainless steel three-way self-draining stay-open ball valve. Valve has 1/2” NPT female drain port to permit water to drain from spray heads after use.

eye/face of bowl: 12 1/2〞diameter stainless steel covered yellow ABS

Heating Cable: Self-regulating heat tracing cable with external braid guards. Heating is controlled by automaticallly that shuts heat off when water temperature inside unit reaches 60℃

Electrical System: Unit is fully wired at the factory. All of components must be anti-exploded.

Pipe and Fittings: 304 stainless steel

Supply: 1 1/4〞NPT female middle inlet.

Quality Assurance: Unit is fully assembled and factory tested prior to shipment.

Attention:Select heating safety stations for moderately warm or lukewarm